Hammerite Direct to Rust Smooth Finish Aerosol Smooth Gold 400ml

Information

Hammerite Direct to Rust Metal Paint in a smooth finish which comes in a handy aerosol can for easy application. It’s specially formulated to perform as a primer, undercoat and topcoat in one. This product can be applied directly to rust and dries quickly to a flawless high sheen finish.

Up to 8 years rust protection

Ultra tough - excellent weather resistance

Smooth glossy finish

Always ensure the surface to be treated is clean, dry and free from any dust, dirt, grease, flaking paint or rust.

Remove any loose paint and debris with a wire brush.

Remove dirt and dust with diluted detergent.

Remove grease then rinse with clean water and allow to dry.

On bare zinc, aluminium and galvanised surfaces, firstly apply primer.

Before applying test a small area to ensure colour and adhesion.

Spray a test patch of Hammerite Direct to Rust Metal Paint onto painted surfaces and leave for 1 hour.

If there is no reaction apply Hammerite Direct to Rust Metal Paint directly to surface.

If there is a reaction remove all paint before applying Hammerite Direct to Rust Metal Paint.

For best results store the aerosol at room temperature for two hours prior to use.

Shake can vigorously in a vertical motion, until the agitator ball is heard and continue to shake for a further 3 minutes.

Spray in light even strokes from a distance of 15cm to avoid runs.

Do not concentrate spray on one spot.

Apply at least 3-4 coats for maximum protection.

Allow 15 minutes between coats .

Between coats invert can and spray for 2 seconds to avoid blockages.

Touch dry 15 minutes.

Recoat after 15 minutes.

Note: Always follow the manufacturer instructions found on the tin.